Skip to content

Request a visit

Tell us what is going on and where. We come back with a time and a number.

Emergency? Call (928) 358-2546. We answer our own phone.

EV Charging

Ford EV Charger Installation

Ford Connected Charge Station and Mobile Charger installs.

What the job involves

Ford Connected Charge Station and Mobile Charger installs. The part that takes the time is not the install. It is verifying what is already in the wall before anything new lands on it.

There is no mystery to it. It goes in this order. Half of these calls turn out to be a different problem than the one that got reported, which is why we test before we quote.

How we handle it

  • Load calculation before any equipment is ordered
  • Continuous load sizing at 125 percent
  • Mounted where the cable reaches without strain
  • Tested at full draw before sign off

Doing this in the White Mountains

Houses up here run on long service drops and a lot of them were wired for a cabin load, not a full-time household.

Elevation, weather, and the age of the housing stock all change how this work goes here compared with a valley city. Equipment ages faster in this sun, monsoon surge is a real load on the system, and a lot of these houses were built as seasonal property and are now carrying full-time demand.

We hold a C-11 commercial license and an R-11 residential license, and the work is done to the code the inspector here actually enforces.

Hardwired or a receptacle, and what you give up

Both are legitimate and they trade against each other. A receptacle lets you unplug the unit and take it with you, and it lets a failed charger be swapped without an electrician. Hardwiring lets you go above forty-eight amps, removes the plug as a failure point, and is what most manufacturers specify for outdoor installations.

The plug is the part people underestimate. A fourteen fifty receptacle carrying forty amps for six hours a night is doing work no dryer outlet was ever designed for, and the builder grade versions sold in bulk overheat and char at the blades. If it is going to be a receptacle, it needs to be an industrial grade one.

We ask how long you plan to stay in the house and whether the charger is likely to change, and the answer to those two questions usually decides it without much debate.

Mounting, cable, and the things you notice later

The install details that matter in year two are boring ones. Whether the cable reaches the charge port without stretching across the walkway. Whether the unit is mounted at a height where the cable hangs rather than coils on the floor. Whether you can still get past the car with the cable connected.

Outdoor installs need equipment rated for it, and at this elevation ultraviolet exposure is harder on plastics than the winter is. A unit rated for outdoor use in a mild climate is not automatically a unit that will look good here in five years.

We commission at full draw before leaving, with the vehicle connected where possible. A charger that energizes is not the same as a charger that delivers its rated current without faulting.

A new Tesla Wall Connector still in its box in a truck bed with the cable coiled beside the mounting bracket
Ford EV Charger Installation work in the White Mountains, Arizona.

Load management as an alternative to a panel upgrade

If the panel is full or the service is tight, there is a middle path that gets overlooked. Load management devices monitor the total draw and throttle or pause the charger when the rest of the house is busy.

In practice the house almost never needs full capacity at 2am, which is when the car is charging anyway. A managed circuit can deliver a full charge overnight on a service that a raw load calculation says cannot support the charger at all.

It is not the right answer everywhere. But it is frequently thousands of dollars cheaper than a service upgrade and it is worth pricing both ways before deciding.

What you get

  • LicensedC-11 #192532 and R-11 #192533
  • PriceFirm, before the work starts
  • Who shows upThe person who quoted it
  • PermitsHandled where the job needs them
  • AfterLabeled, documented, and cleaned up

You should be told what was actually wrong, not just that it is handled now.

Load management as an alternative to a panel upgrade

If the panel is full or the service is tight, there is a middle path that gets overlooked. Load management devices monitor the total draw and throttle or pause the charger when the rest of the house is busy.

In practice the house almost never needs full capacity at 2am, which is when the car is charging anyway. A managed circuit can deliver a full charge overnight on a service that a raw load calculation says cannot support the charger at all.

It is not the right answer everywhere. But it is frequently thousands of dollars cheaper than a service upgrade and it is worth pricing both ways before deciding.

Choosing the amperage honestly

Bigger is not automatically better. A 48 amp charger on a house that can only support it by upgrading the service is often worse value than a 32 amp charger that fits the existing panel and still adds well over a hundred miles overnight.

The useful question is not how fast the charger can go, it is how many miles you drive in a day and how many hours the car sits at home. For almost every household the answer makes 32 or 40 amps entirely sufficient.

Where higher amperage genuinely earns its cost is a two-EV household, a long daily commute, or a vehicle with a very large battery that you regularly run low.

Questions we get

Level 1 or Level 2?

Level 1 is a standard outlet and adds a few miles an hour. Level 2 is 240 volt and fills overnight. For anyone driving daily, Level 2 is the real answer.

Can my house handle a charger?

That depends on your service size and what else is on it. A load calculation answers it in about twenty minutes and it is worth doing before you buy equipment.

Can the charger go outside?

Yes, with equipment rated for it. At this elevation the sun is as hard on outdoor gear as the cold is, so the rating matters.

Do you clean up?

The work gets left labeled and clean enough that the next electrician can read what we did.

Will you explain what you found?

Always. You get told what the problem actually was, not just that it is handled.

Get it handled

Call (928) 358-2546 or send a message and we will work out what the job actually is.

See recent work or send the details and we will come look.