New Construction
New Home Electrical Wiring
A complete residential rough-in coordinated with your builder.
What the job involves
A complete residential rough-in coordinated with your builder. This is one where the cheap version and the correct version look identical on day one and completely different in year three.
The order of operations matters more than the parts list. We see this go wrong most often when someone extended an existing circuit instead of running a new one.
How we handle it
- Plan reviewed and load calculated before rough in
- Rough in coordinated with the other trades
- Inspections staged so nothing waits on us
- Trim finished and every circuit tested at completion
Doing this in the White Mountains
Winter here means well pumps, heat tape, and space heaters all landing on a service that was sized decades ago.
Elevation, weather, and the age of the housing stock all change how this work goes here compared with a valley city. Equipment ages faster in this sun, monsoon surge is a real load on the system, and a lot of these houses were built as seasonal property and are now carrying full-time demand.
We do not upsell a panel when the problem is a loose neutral, and we do not patch a service that needs replacing.
Rough-in is where the decisions get locked
The electrical rough-in happens after framing and before insulation, and it is the moment nearly every decision becomes permanent or expensive. Where the outlets go, how many circuits the kitchen gets, whether the garage is ready for a charger later.
Adding capacity at rough-in is cheap because the walls are open. A spare conduit to the garage, an extra circuit to the panel, a conductor for a future fan, all close to free now and all significant work afterward.
This is the stage to think two owners ahead rather than to the day you move in.
Temporary power before anything else
The first electrical work on any build is the temporary service, and it is worth doing properly rather than as an afterthought. Framers, roofers, and mechanical crews are all going to run tools off it for months, frequently in weather.
That means a pole set where it will not be in the way of the excavation or the driveway, protection sized for what the trades will actually plug in, and receptacles with ground fault protection because everything on a construction site is damp and grounded.
It also means coordinating with the utility early. Getting temporary power to a lot can take longer than people plan for, and a framing crew waiting on electricity is an expensive kind of delay.
Stubs and spares while the walls are open
The cheapest capacity a house will ever have is the capacity added before the drywall. An empty conduit from the panel to the attic, another to the garage wall, and one to whichever exterior wall faces the future shop or hot tub cost almost nothing in an open frame.
The same applies to the panel itself. Specifying more spaces than the load calculation demands, and leaving those spaces genuinely empty rather than filling them with tandem breakers, is what keeps the next addition from becoming a service upgrade.
Ten years from now somebody wants a charger, a mini split in the bonus room, or a well house heater. Every one of those is a straightforward job in a house that was stubbed for it and a wall-opening job in one that was not.
What you get
- LicensedC-11 #192532 and R-11 #192533
- PriceFirm, before the work starts
- Who shows upThe person who quoted it
- PermitsHandled where the job needs them
- AfterLabeled, documented, and cleaned up
The cheap version and the correct version look identical for about a year.
Stubs and spares while the walls are open
The cheapest capacity a house will ever have is the capacity added before the drywall. An empty conduit from the panel to the attic, another to the garage wall, and one to whichever exterior wall faces the future shop or hot tub cost almost nothing in an open frame.
The same applies to the panel itself. Specifying more spaces than the load calculation demands, and leaving those spaces genuinely empty rather than filling them with tandem breakers, is what keeps the next addition from becoming a service upgrade.
Ten years from now somebody wants a charger, a mini split in the bonus room, or a well house heater. Every one of those is a straightforward job in a house that was stubbed for it and a wall-opening job in one that was not.
Coordinating with the other trades
Electrical rough-in sits between framing and drywall, sharing the wall cavities with plumbing and mechanical. Whoever arrives last finds the good routes taken.
Good coordination means knowing where the ductwork and the drain stacks are going before drilling, and it means not notching structure that the framer needs.
We plan around the other trades rather than through them, which is slower on the day and considerably faster across the project.
Questions we get
Does new wiring need an inspection?
Yes, and it gets staged so the rough in is signed off before anything is closed up.
Do you have to open all my walls?
No. We fish where the framing allows and open only where there is no route. Minimizing patching is most of the skill in a rewire.
Can we live in the house during a rewire?
Usually yes. We sequence it so the house keeps power throughout, working through it a section at a time.
Do you work on older houses?
Constantly. A lot of the housing up here was built as seasonal property and wired for a much lighter load than it carries now.
What if something is wrong after you leave?
We come back. That is the whole point of being a small local company.
Towns we cover
Based in Pinetop-Lakeside, covering about forty miles out across Navajo County and the western side of Apache County.
- Show LowOur second base. Panel work and service upgrades on the newer builds off Deuce of Clubs.
- Pinetop-LakesideHome ground. Cabin rewires, fixture work at cathedral-ceiling height, and same-week calls.
- SnowflakeLonger runs out to property on acreage, where the well pump and the house share one panel.
- TaylorOlder service entrances that predate the current code, and the corrections that go with them.
- Heber-OvergaardHeavy second-home territory. Freeze-season calls on places that sat empty since fall.
- LindenBetween Show Low and Pinetop. Remodel wiring and additions on established lots.
- GreerHighest elevation we cover. Generator and backup work for a road that closes in weather.
- ConchoWide-open lots on the Apache County side, often with a long feed from the meter to the house.
- OvergaardPonderosa country. Fixture and circuit work in cabins built across four decades.
- LakesideOlder lakefront cabins where the original wiring was never meant for today’s load.
- PinetopThe cabin core. Small jobs, one outlet or one switch, are most of what we do here.
- White Mountain LakeSeasonal places that need a look before the family arrives and after they leave.
Get it handled
Call (928) 358-2546 or send a message and we will work out what the job actually is.
See recent work or send the details and we will come look.